- 论坛徽章:
- 0
|
本帖最后由 dd20020221 于 2016-03-03 16:44 编辑
T5440启动失败了,不知是哪里的问题,请高手指点迷津
问题如下:
-------------------------------------------------------
console显示如下:
sc> poweron
sc> console -f
Enter #. to return to ALOM.
Chassis | critical: Mar 3 07:27:58 FATAL: Polling POK Status Time Out: 0xb7
Chassis | critical: Mar 3 07:27:58 FATAL: The HOST Processor has a configuration error, forcing a power-down
Chassis | critical: CRITICAL ALARM is set
Chassis | critical: Host has been powered off
Serial console stopped.
SC上showfaults和showenvironment也没有发现什么错误,如下:
sc> showfaults
Last POST Run: Wed Sep 30 13:38:34 2015
Post Status: Passed all devices
No failures found in System
sc> showenvironment
--------------------------------------------------------------------------------
System Temperatures (Temperatures in Celsius):
--------------------------------------------------------------------------------
Sensor Status Temp LowHard LowSoft LowWarn HighWarn HighSoft HighHard
--------------------------------------------------------------------------------
CPU temperature information cannot be displayed when the System power is off
/SYS/MB/T_AMB OK 26 -20 -10 -8 70 75 80
/SYS/PDB/T_AMB OK 26 -20 -10 -8 70 75 80
/SYS/MB/PCI_AUX/T_AMB OK 24 -20 -10 -8 70 75 80
--------------------------------------------------------------------------------
System Indicator Status:
--------------------------------------------------------------------------------
/SYS/LOCATE /SYS/SERVICE /SYS/ACT
OFF OFF STANDBY BLINK
--------------------------------------------------------------------------------
Disk Status information cannot be displayed when the System power is off
--------------------------------------------------------------------------------
Fan Status information cannot be displayed when the System power is off
--------------------------------------------------------------------------------
Voltage Rail Status information cannot be displayed when the System power is off
--------------------------------------------------------------------------------
System Load information cannot be displayed when the System power is off
--------------------------------------------------------------------------------
Current sensor information cannot be displayed when the System power is off
--------------------------------------------------------------------------------
Power Supplies:
--------------------------------------------------------------------------------
Supply Status Fan_Fault Temp_Fault Volt_Fault Cur_Fault
--------------------------------------------------------------------------------
/SYS/PS0 OK OFF OFF OFF OFF
/SYS/PS1 OK OFF OFF OFF OFF
/SYS/PS2 OK OFF OFF OFF OFF
/SYS/PS3 OK OFF OFF OFF OFF |
|