论坛徽章:: 0

电梯直达

1楼 [收藏(0)] [报告]

发表于 2003-09-13 08:26 |只看该作者 |倒序浏览

本文着重介绍HP Proliant系列服务器安装SCO Openserver Release 5操作系统的关键步骤，以及各种硬件驱动的加载方法。
　　从www.hp.com下载最新的驱动（EFS）
具体步骤：

1、加载硬盘控制器BTLD包。
用SCO启动光盘或软盘启动服务器，在Boot：提示符后输入BTLD字符串
各种控制器的Boot字符串对照表如下（以BTLD包ad160为例）：

阵列控制器所属大类 BTLD  包名 SCO 5.0.5 Boot串 SCO 5.0.6 Boot串
2/E（EISA） Drive Array ida defbootstr disable=ida link=ida hd=ida0 Srom=wd(0,0,0) defbootstr disable=ida link=ida hd=ida0 Srom=wd(0,0,0)
2/P（PCI）
2SL
2DH
3100es
3200
221
4200 Smart Array-2  Controller clad defbootstr link=clad hd=Sdsk Srom=wd(0,0,0) defbootstr link=clad hd=Sdsk Sdsk=clad(0,0,0,0) Srom=wd(0,0,0)
4250ES
ROC
431
5300 Smart Array 5x Controller ciss defbootstr link=ciss hd=Sdsk Srom=wd(0,0,0) defbootstr link=ciss hd=Sdsk Sdsk=ciss(0,0,0,0) Srom=wd(0,0,0)
5i *
532 *
SCSI控制器
Wide Ultra SCSI 3 32-Bit SCSI Controller cha defbootstr link=cha hd=Sdsk Srom=wd(0,0,0) defbootstr link=cha hd=Sdsk Sdsk=cha(0,0,0,0) Srom=wd(0,0,0)
Ultra 2
Ultra 3 64-Bit/66-Mhz Dual Channel Wide Ultra3 SCSI ad160 defbootstr link=ad160 hd=Sdsk Srom=wd(0,0,0) scsi.noscan defbootstr link=ad160 hd=Sdsk Sdsk=ad160(0,0,0,0) Srom=wd(0,0,0) scsi.noscan
IDE控制器
CD-ROM on 2nd IDE Controller as master drive                                                                                     HD on 1st IDE Controller as master drive defbootstr Srom=wd(1,0,0) defbootstr Srom=wd(1,0,0)
CD-ROM on 1nd IDE Controller as slave drive                                                                                        HD on 1st IDE Controller as master drive defbootstr Srom=wd(0,1,0) defbootstr Srom=wd(0,1,0)

2、按照提示插入BTLD包软盘，即EFS 5张软盘中的第3张。回车继续
3、如果是5.0.6，屏幕会提示（以加载ad160包为例）：
Driver <ad160>; apparently should be replaced with the new driver "ad160".
Replacing a driver may result in a kernel which does not work.
Please enter
   'r' if you wish to try replacement
   'a' if you want to use block and character major
   9[default], which block and character major number
   (0-100) to use('?' to list), or 'q' to quit:

4、键入r，回车继续安装

注意：
1、只能把系统安装在第一个（Primary）控制器上，所以要调整控制器的顺序
l 对于老产品：通过SmartStart光盘上的System Configuration Utility工具设置Primary Controller的Controller Order为First。如果是Wide Ultra2或更老的SCSI控制器，还必须设置Host Adapter number为0
l 对于新产品：需要通过F9/F10进入工具，设置Primary Contraller

2. 对于SCO OpenServer 5.0.4，如果需要使用IDE设备（光驱或硬盘），需要用oss478a（ATAPI (IDE) driver BTLD）软盘启动系统。

3. 如果使用SCSI光驱安装系统，需要oss604a – SCSI光驱补丁的软盘启动服务器，并且把boot字符串最后的‘Srom=wd（x，x，x）’去掉。

4. 如果当前硬盘上有系统，建议用SmartStart光盘引导服务器后，重新设置操作系统为SCO OpenServer，并指定Primary Controller。必要时可以清除整个硬盘（Erase）

5. 对于SCO OpenServer 5.0.5操作系统，应该使用操作系统提供的boot软盘引导服务器。如果用光盘直接引导，需要在Boot：提示后输入如下字符串：

mem=1k-64k, 64k-128k, 1m-16m, 16m-64m, 64m-128m/s/n

附录一：EFS包含工具
l Compaq SCSI-2 Management Utility
l Compaq Intelligent Drive Array (IDA) Diagnostic Utility
l Compaq System Monitor Utility
l Compaq Single Launch Point Utility
l Compaq CPQULTRA Diagnostic Utility
l Compaq CASA Diagnostic Utility
l Compaq CLAD Diagnostic Utility
l Compaq Network Interface Manager Utility
l Compaq EFS Version Utility
l Compaq CISS Diagnostic Utility
l Compaq Integrated Management Log Utility
EFS包含设备驱动（BTLD包见附录二）
l Compaq Network Controller drivers
l Compaq SCSI-2 driver
l Compaq ProLiant Storage System driver
l Compaq System Wellness driver
l Compaq Intelligent Drive Array AND SMART-2 ARRAY driver(ida)
l Compaq Array Driver(clad)
l Compaq Fibre-Channel driver
l Compaq Remote Insight driver
l Compaq 64-Bit/66-Mhz Ultra-3 SCSI Driver(ad160)
l Compaq Intelligent Storage Subsystem Driver(ciss)

附录二：控制器和BTLD包名对照表
Hardware Supported                                  Package name
----------------------------------------------------------------------
Compaq 32-Bit Fast SCSI-2 Controller                         cha
Compaq 32-Bit Fast-Wide SCSI-2/E Controller
Compaq 32-Bit Fast-Wide SCSI-2/P Controller
Compaq 32-Bit Fast-Wide Ultra SCSI Controller
Compaq 32-Bit Fast-SCSI-2 Controller
Compaq Dual Channel Wide-Ultra SCSI-3 Controller
Compaq 64-Bit Dual Channel Wide-Ultra-2 SCSI Controller
----------------------------------------------------------------------
Compaq 64-Bit/66-Mhz Dual Channel Wide Ultra3 SCSI Adapter ad160
Compaq 64-Bit/66-Mhz Wide Ultra3 SCSI Adapter
----------------------------------------------------------------------
Integrated SCSI-2 Options port                               ccs
----------------------------------------------------------------------
Intelligent Drive Array Controller                           ida
Intelligent Drive Array Expansion Controller
Intelligent Drive Array-2 Controller
Compaq Intelligent Drive Array
SMART Controller
SMART-2/E Controller
SMART-2/P Controller
SMART-2/SL Controller
SMART-2/DH Controller
Smart 3100 ES Controller
Smart 3200 Controller
Smart 221 Controller
----------------------------------------------------------------------
Integrated Smart Controller                                    clad
Smart 4200 Controller
Smart 4250 ES Controller
Smart 431 Controller
RAID LC2 Controller
----------------------------------------------------------------------
Smart Array 5300 Controller                               ciss
Smart Array 5i Controller
Smart Array 532 Controller